Thresholds Page

This wizard page enables you to define thresholds for the selected measurement.

Important information

General information about this wizard is available here: Service Level Agreement Wizard.

Wizard map

The Service Level Agreement Wizard contains:

Introduction > Measurement Page > Transactions Page > Load Criteria Page > Thresholds Page > Summary Page

See also

Service Level Agreements Overview

User interface elements are described below (unlabeled elements are shown in angle brackets):

UI Elements

Description

Measurement

The measurement selected for the SLA.

Percentile

Percentage of transactions to measure against the configured threshold.

Available for the following measurement: Transaction Response Time Percentile

Apply to all transactions

Enables you to define a threshold or a set of thresholds for all of the listed transactions. Click to apply the thresholds to all of the listed transactions simultaneously.

Note: Threshold values for the transactions do not have to be the same. You can assign different values for each transaction.

Available for the following measurement: Average Transaction Response Time

Provide a threshold value for all transactions

Enables you to define one threshold for all of the listed transactions. Click to apply the value to all of the listed transactions simultaneously.

Note: The threshold values for the transactions do not have to be the same. You can assign different values for each transaction.

Available for the following measurements: Transaction Response Time Percentile

Threshold/<Threshold table>

The minimum/maximum threshold value for the selected measurement.

  • Transaction Response Time Percentile: If the resulting value over the whole run exceeds the defined threshold values, the SLA produces a Failed status.

  • Average Transaction Response Time and Errors per Second: If the resulting value over the specified time interval exceeds the threshold values, the SLA produces a Failed status for that time interval.

  • Average/Total Throughput and Average Hits per Second/Total Hits: If the resulting value over the whole run is lower than the threshold value, the SLA produces a Failed status.

Note:  

  • Transaction Response Time Percentile and Average Transaction Response Time: When more than one transaction is selected, all of the transactions are listed in a table enabling you to define thresholds for each transaction separately.

  • Average Transaction Response Time and Errors per Second: When a load criterion is selected, the table displays the load value ranges, enabling you to define thresholds per range of load values. For details, see Load Criteria Page.